Which Joe gave his name to ‘sloppy joes’? We look at five interesting sandwiches and their lexical origins.
1 Enlarge and bevel the rim of (a drilled hole) so that a screw, nail, or bolt can be inserted flush with the surface.
- ‘Construction began by countersinking the holes for the bolster rivets slightly.’
- ‘All the clamp holes of the panels were countersunk with this bit so that the screw heads are flush.’
- ‘Drill four 3/16-inch clearance holes in each rib before countersinking the top surface to bring the screw head flush.’
- ‘Drill and countersink screw holes for mounting screws.’
- ‘I've also countersunk the holes so no screwheads stick up later on.’
- 1.1Drive (a screw, nail, or bolt) into a countersunk hole.
- ‘You can even countersink and cover the screws with a dab of caulk.’
- ‘Imagine driving a two-inch finish nail into solid oak with no predrilling and having it perfectly countersunk, all in less time than it takes to pick up a hammer.’
- ‘To help prevent recurrence, countersink the nails and swab the holes with a water repellent.’
- ‘Nail heads should be flush with the surface, but not countersunk as it can cause the backer board to crack or break.’
- ‘Use 12 or 16 HDG finishing nails and countersink them with a nail set.’
- ‘First, countersink the nails and swab the holes with a water repellent.’
- ‘Then secure with 1-inch drywall screws, making sure they are countersunk.’
- ‘After the first sanding, check to see if any nails are now protruding, and, if so, countersink them.’
- ‘Keep in mind, if you are using spring metal, that the nail heads should be slightly countersunk so that they do not catch on the opposite rail when the window is opened.’
- ‘Fasten the bottom of each brace with a 6-inch machine bolt and countersink the washer and nut.’
- ‘Depending on how far the bolts stick out beyond the boards, we either countersink the nuts or wrap two layers of duct tape over the ends of the bolts to prevent damage to the greenhouse film.’
- ‘A thin layer of thinset adhesive is applied to the top of the plywood using a notched trowel, then the cement board is put in place and secured with flathead screws that are countersunk into the surface.’
- ‘Just get plenty of screws in and make sure that they are countersunk and that they hit the studs.’
- ‘Use a nail punch to countersink all nail heads approximately 1/8 ‘below the wood surface.’’
- ‘Search out any protruding nail heads and countersink them with a nailset.’
- ‘It's helpful to first pre-drill a small hole in the wood where you want to countersink the brass screws.’
- ‘There is a second layer of plexi to attach to this, so I countersunk the screwheads so they were flush’
- ‘When applying directly over an old floor, countersink any protruding nails and sand off any paint, wax, or varnish that might affect the adhering ability of the adhesive.’
- ‘Flat heads are always countersunk or rest flush with the surface.’
- ‘I used regular wood screws and countersunk them in the PVC to allow a flush surface.’
Are you looking for a word for a foolish person? We explore twelve interesting words to describe the dunderheads in your life.
Before you run for the hills, let’s run through a list of ‘run’ expressions that are running through our minds.
The definitions of ‘buddy’ and ‘bro’ in the OED have recently been revised. We explore their history and increase in popularity.